XUD9TE engine has a higher flow oil pump than it’s little sibling XUD7TE. Don’t yet know why, but at least to my knowledge, extra oil flow and consecutively pressure will not harm. Actually, higher oil flow helps lubricating and cooling. Continue reading Uprated oil pump
XUD7 turbo motors (XUD7TE, XUD7T) have a camshaft with smaller lift and narrower lobes compared to later XUD7 atmospherics and XUD9 motors. Both camshafts have their pros and cons. Table below summarizes camshaft timing data.
Continue reading XUD7TE camshaft upgrade
I like measuring things. And I hate loose definitions like “not too much”. How much is not too much? Thus when I decided to check my Garrett T2 turbo before putting it back.
- excess oil in air outlet. Some oil will always be there from breather, but too much might indicate leaking turbo. And that is a small problem which can lead to a large one: engine runaway.
- shaft is turning freely, without noise, sticking, touching anything.
- axial play (forward-backward). For T2 it should be 0.025 – 0.084 mm. I measured it to be roughly 0.07 mm. Such play is virtually unnoticeable by hand.
- radial play (to sides). Should be 0.056 – 0.127 mm, but can be bit higher as long as vanes are not hitting anything and turning freely. Push axis to one side and use clearance gauge to measure distance to turbo side, then push it to other side and measure again. Difference is the clearance you are looking for.
- wastegate operation. It should move freely.